ban

How to install Pu Foam Seals?

  • Categories:Company news
  • Author:
  • Origin:
  • Time of issue:1563959069000

How to install Pu Foam Seals?

(Summary description)1.ThePuFoamsealsshouldnotbepulledtootightly.Itshouldbesetinplaceduringinstallationandthesurfaceshouldbestraight.2.APuFoamsealsisinstalledateachcornerandshouldbecutintoagapofabout80-85degreesontheinsid

  • Categories:Company news
  • Author:
  • Origin:
  • Time of issue:2019-07-24 17:04
1. The Pu Foam seals should not be pulled too tightly. It should be set in place during installation and the surface should be straight.
2. A Pu Foam seals is installed at each corner and should be cut into a gap of about 80-85 degrees on the inside,but it cannot be cut short,stick with glue.At right angle also leave about 1mm  on the edge.
3. After the Pu Foam seals are installed in the groove at the cut-out, they are pressed and fixed to each other to prevent the joint from being broken when the seals is contracted, 
 

Scan the QR code to read on your phone

Returns list

Enterprise strength

 

Honor

Equipment

这是描述信息

扫一扫,访问微信公众号

Copyright Hebei Cuishi Rubber and Plastic Products Technology Co., Ltd., 冀ICP备09011681号    www.300.cn