Hebei Cuishi Rubber Products Technology Co., Ltd.,
Tel:0311-85151177
General manager:Elena Zhang
Mobile phone:+8616631141393
Mail:elena@chinacuishi.com
Add.: Yangerzhuang Industry & Trade District, Qinghe County, Hebei Province

Your present location:News >> Company News >> How to install Pu Foam Seals?

Font Size:big  middle  small

How to install Pu Foam Seals?

Number of visits: Date:2019年3月6日 08:59
Image
1. The Pu Foam seals should not be pulled too tightly. It should be set in place during installation and the surface should be straight.
2. A Pu Foam seals is installed at each corner and should be cut into a gap of about 80-85 degrees on the inside, 
    but it cannot be cut short,stick with glue.
    At right angle also leave about 1mm  on the edge.
3. After the Pu Foam seals are installed in the groove at the cut-out, they are pressed and fixed to each other to prevent the joint from being broken when the seals is contracted, 
   and an opening is formed to affect the sealing property.

TypeInfo: Company News

Keywords for the information:CUISHI  SEAL  DOOR SEAL  FOAM SEAL